Current Location:Home >> Download
  •  

    Standard Size of PCB Card


    PCB insert board installation position in panel(with type II handle)

      

     

       The groove width can accommodate 1.6±0.2 mm printed circuit board, which complies with
       IEC 249-2 standard  

       Guide A complies with IEC 297-3-101 standard 
       Guide B is equipped with the jack and pin code guide pinhole, according with IEC 60 297-3-
       103x standard

       Guide C is guide B shifted 2.54 mm to the right, which is used when there are components
       on the back side. 

       

     

    Depth calibration 

                            

     

        

     

    Notes:
    DC: The calibrate size of the front of the plug-in box
    (the space from the backside of front panel to the rear panel connector terminal)

    RDC: The calibrate size of the rear of the plug-in box
    (the space from the backside of rear panel to the rear panel connector terminal)

    Dt2: The inspection size of the front plug-in card
    (the space from the backside of front panel to the panel connector terminal)

    RDt2: The inspection size of the rear plug-in card
    (the space from the backside of rear  panel to the panel connector terminal)

     

    The design of print circuit board for subracks

     

     

      

     

Rising Subracks is specialized in electronic equipment and hardware support equipment manufacturing, such as 19″aluminum profile enlosures, sub rack, vice-chassis, cabbiage, caninet, frame, panel and so on. We are good at product customization. Our products meet various bus back panel installation requirements, including ATCA、VME/VME64x、PCI、CPCI、COTS

Internationally renowned chassis supplier:SCHROFF  RITTAL  VEROTEC  ELMA  PENTAIR  DANIELS ERVTEC  ATOS  SRS